Mass storage device mounting bracket
Description Spare part number
Mounting bracket, solid-state drive 856013-001
Mounting bracket, hard disk drive 856012-001
Before disassembling the hard drive or solid-state drive, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the keyboard/top cover (see Keyboard/top cover on page 34).
5. Remove the battery (see Battery on page 42).
6. Remove the hard drive or solid-state drive (see Hard drive or solid-state hard drive on page 43).
If it is necessary to replace the mass storage device cable or mounting bracket:
1. Remove the mass storage device cable from the device (1).
2. Remove the four Phillips PM3.0×3.7 screws (2) that secure the mounting bracket to the mass storage
device.
Component replacement procedures 45
To Next Page
Loading...
Need help?
General
