Poly Studio Base Kit G9 Plus out-of-box
setup
4
Before powering on the HP Mini IP Conferencing PC and Poly TC10, ensure all connections have been
made from the HP Mini IP Conferencing PC to the Poly TC10 and other peripherals.
Refer to Cabling the Poly Studio Base Kit G9 Plus system on page 6 for more.
Complete the Windows out-of-box set up on Poly TC10
Use the Poly TC10 device to set up your Poly Studio Base Kit G9 Plus and configure basic settings.
IMPORTANT: During the setup process, the conferencing PC and Poly TC10 may reboot several times.
Do not turn off or restart the conferencing PC or Poly TC10 during this process.
1. Connect all peripherals to the HP Mini IP Conferencing PC, including Poly TC10.
2. Connect the conferencing PC to your network with an ethernet cable.
3. Connect the HP Mini IP Conferencing PC to power.
The conferencing PC and Poly TC10 device turn on. Poly TC10 automatically pairs with the MTRoW
device and launches the Microsoft Teams setup sequence.
NOTE: The language of the Poly TC10 interface is inherited from the language set on the paired
PC.
Update a Poly TC10 device
If your Poly TC10 is running 5.x or lower, it won't pair with the HP Mini IP Conferencing PC running MTRoW.
Upgrade to Poly TCOS version 6.x to pair it to the HP mini PC.
1. Plug your Poly TC10 into a public/corporate network with internet connectivity using POE or a POE
injector.
2. During the out-of-box installation sequence your Poly TC10 automatically checks for an update and
prompts you to accept. Accept the update to allow your software to upgrade to the latest version.
NOTE: If you have a Poly TC10 that was previously set up, perform a reset of the Poly TC10 to go
through the out-of-box installation sequence mentioned above.
Poly Studio Base Kit G9 Plus out-of-box setup
9
To Next Page