System Configuration menu
NOTE: Some of the menu items listed in this section may not be supported by your computer or your
operating system.
Select To do this
Language Change the Computer Setup language.
Boot options
●
Set an f9, f10, and f12 delay when starting up.
●
Enable/disable CD-ROM boot.
●
Enable/disable floppy boot.
●
Enable/disable internal network adapter boot.
●
Enable/disable MultiBoot, which sets a boot order that
can include most boot devices in the system.
●
Set the Express Boot Popup delay in seconds.
●
Set the boot order.
◦
1st boot device: USB CD-ROM
◦
2nd boot device: USB floppy
◦
3rd boot device: USB SuperDisk
◦
4th boot device: Notebook hard drive
◦
5th boot device: USB hard disk
◦
6th boot device: Network controller
Device Configurations
●
Swap the functions of the fn key and left ctrl key.
●
Enable/disable USB legacy support. When enabled, USB
legacy support allows the following:
◦
Use of a USB keyboard in Computer Setup even
when a your operating system is not running.
◦
Startup from bootable USB devices, including a hard
drive, diskette drive, or optical drive connected by a
USB port to the computer.
●
Enable/disable BIOS DMA data transfers.
●
Enable/disable fan always on while connected to an AC
outlet.
●
Enable/disable data execution prevention.
●
Enable/disable LAN power saving mode.
●
Enable/disable SATA Native Mode.
●
Enable/disable Dual Core CPU.
●
Enable/disable HDD translation mode.
Computer Setup menus 87
To Next Page
Loading...
Need help?
General
