NOTE: The WWAN module is designed with a notch to prevent incorrect insertion.
Solid-state drive
To remove the SSD, use this procedure and illustration.
Table 5-3
SSD descriptions and part numbers
Description Spare part number
For use in all countries and regions except the People's Republic of China
1 TB, M.2 2280, PCIe-4×4, NVMe, value SSD N45474-001
512 GB, M.2 2280, PCIe-4×4, NVMe, SSD N45476-001
256 GB, M.2 2280, PCIe-4×4, NVMe SSD N45477-001
For use only in the People's Republic of China
1 TB, 2280, PCIe-4×4, NVMe, value SSD N77394-001
512 GB, 2280, PCIe-4×4, NVMe, value SSD N77392-001
256 GB, 2280, PCIe-4×4, NVMe, value SSD N77391-001
Before removing the SSD, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 38).
2. Remove the bottom cover (see Bottom cover on page 38).
3. Disconnect the battery cable from the system board (see Battery on page 50).
NOTE: The type of SSD cover differs for models with a plastic bottom cover or a metal bottom cover.
Remove the SSD from models with a plastic bottom cover:
1. Remove the Phillips M2.0 × 2.5 screw (1) and the Phillips M2.0 × 4.0 screw (2) that secure the SSD and
shield to the computer.
Solid-state drive
43
To Next Page
Loading...
