3. Release the battery (3) by sliding it to the left, and then remove the battery (4) from the computer.
To install the battery, reverse the removal procedures.
Speakers
To remove the speakers, use this procedure and illustration.
Table 6-2
Speakers description and part number
Description Spare part number
Speakers (include left and right speakers, cables, and six rubber isolators) N96463-001
Before removing the speakers, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 50).
2. Remove the bottom cover (see Bottom cover on page 38).
3. Disconnect the battery cable from the system board (see Battery on page 50).
Remove the speakers:
1. Disconnect the speaker cable (1) from the system board.
2. Release the speaker cables from the retention clips (2) that are built into the computer.
3. Remove the six Phillips M2.0 × 2.0 broadhead screws (3) that secure the speakers to the computer.
4. Remove the speakers (4) from the computer.
NOTE: When removing the speakers, make note of the location of the rubber isolator locations (5).
The absence of or damage to these isolators can result in degraded speaker performance.
52
Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
