8. Remove the Phillips M2.0 × 3.0 screw (2) from the drive, and then pull the drive (3) out of the socket.
To replace the SSD, reverse the removal procedures.
NOTE: The SSD is designed with a notch to prevent incorrect insertion.
Memory modules
To remove the memory modules, use this procedure and illustration.
Table 5-4
Memory module descriptions and part numbers
Description Spare part number
For use in all countries and regions except the People's Republic of China
16 GB, DDR5-5600, 1.1 V N38627-001
8 GB, DDR5-5600, 1.1 V N37792-001
For use only in the People's Republic of China
16 GB, DDR5-5600, 1.1 V N77399-001
8 GB, DDR5-5600, 1.1 V N77398-001
Memory module thermal pad: Included in the Miscellaneous Kit, spare part number N96244-001
Before removing the memory, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 50).
2. Remove the bottom cover (see Bottom cover on page 38).
3. Disconnect the battery cable from the system board (see Battery on page 50).
If you are replacing a memory module, remove the existing memory module:
46
Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To Next Page
Loading...
