1. Remove the memory module shield (1).
IMPORTANT: When replacing the memory module shield, be sure to insert the edges of the shield
into the clips (2) that are built into the system board.
The memory module shield is included in the Miscellaneous Kit, spare part number N96244-001.
To protect a memory module after removal, place it in an electrostatic-safe container.
2. Spread the two retention clips outward (1) until the memory module tilts up at a 45° angle, and then
remove the module (2). Use the same procedure to remove all memory modules.
IMPORTANT: To prevent damage to the memory module, hold the memory module by the edges
only. Do not touch the components on the memory module.
To protect a memory module after removal, place it in an electrostatic-safe container.
Memory modules
47
To Next Page
Loading...
