2. Remove the fingerprint reader cable (2) from the computer.
To replace the fingerprint reader cable, reverse the removal procedures.
Touchpad cable
To remove the touchpad cable, use this procedure and illustration.
The touchpad cable is included in the Cable Kit, spare part number N96922-001.
Before removing the touchpad cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 50).
2. Remove the bottom cover (see Bottom cover on page 38).
3. Remove the battery (see Battery on page 50).
Remove the touchpad cable:
1. Release the ZIF connector (1) the touchpad cable is connected to, and then disconnect the
touchpad cable from the system board.
2. Release the ZIF connector (2) the touchpad cable is connected to, and then disconnect the
touchpad cable from the touchpad.
Touchpad cable
71
To Next Page
Loading...
