13. Remove the three Phillips M2.0 × 4.0 screws (2) that secure the system board and I/O bracket to
the computer.
14. Remove the I/O bracket (1).
The I/O bracket is included in the Plastics/Rubber Kit, spare part number N97208-001.
15. Lift the left side of the system board (2) until it rests at an angle, and then remove the system
board (3) by sliding it up and to the left at an angle.
To install the system board, reverse the removal procedures.
I/O board cable
To remove the I/O board cable, use this procedure and illustration.
The I/O board cable and nano SIM cable are included in the Cable Kit, spare part number N96922-001.
58
Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
