4. Release the WWAN antenna cables and the display tuner cable from the retention clips (4) that are
built into the I/O holder.
5. Remove the WLAN antenna plate (1) that secures the WLAN antenna cables to the WLAN module.
The WLAN antenna plate is included in the Miscellaneous Kit, spare part number N96244-001.
6. Carefully disconnect the WLAN antenna cables (2) from the terminals on the WLAN module.
Computer models have either one or two WLAN antennas. On models with two antennas, the #1
WLAN antenna cable connects to the WLAN module #1 Main terminal. The #2 WLAN antenna cable
connects to the WLAN module #2 Aux terminal.
7. Release the ZIF connector the display panel cable (3) is connected to, and then disconnect the
display panel cable from the system board.
8. Release the WLAN antenna cables and the display panel cable from the retention clips (4) that are
built into the left I/O holder.
62
Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
