a. Use a thin plastic tool (1), such as a case utility tool, to separate the outside edges of the
display bezel from the display assembly.
b. In the following sequence, release the top (2), left (3) and right, and bottom (4) edges of the
display bezel from the display assembly.
c. Remove the display bezel (5).
The display bezel is available using the following spare part numbers:
● N96947-001: For use on computer models equipped with an infrared webcam
● N96946-001: For use on compuer models equipped with an FHD webcam
● N96948-001: For use on computer models not equipped with a webcam
14. To remove the display panel:
a. Remove the display bezel.
b. Locate the display panel retention tape (1) in the upper and lower corners of the
display assembly.
c. Use a pair of tweezers to grasp the tape (2).
64
Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
