e. When replacing the display panel retention tape, place the tape in the locations shown in the
following image.
f. Release the display panel cable (1) from the retention clips and routing channel that are built
into the bottom edge of the display back cover.
g. Lift the top edge of the display panel (2) and swing it up and forward until it rests upside down
in front of the display back cover.
h. Release the retention tape (3) that secures the display panel cable to the display panel.
i. Release the retention bar (4) that secures the display panel cable to the display panel.
j. Disconnect the display panel cable (5) from the display panel.
k. Remove the display panel.
The display panel is available using the following spare part numbers:
● N98661-001: 40.6 cm (16.0 in), WUXGA, antiglare, LED, UWVA, TOP display panel; typical
brightness: 300 nits
62
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
