2. Remove the SSD shield (3).
The SSD shield is included in the SSD Support Parts Kit, spare part number N96251-001.
3. Remove the SSD (4) by pulling the drive away from the slot at an angle.
4. Thoroughly clean the thermal material from the surfaces of the SSD (1) and the SSD shield (2) each
time you remove the SSD. Replacement SSD thermal material is included in the SSD spare part kit.
The following illustration shows the replacement thermal material locations.
To replace the SSD, reverse the removal procedures.
NOTE: The SSD is designed with a notch to prevent incorrect insertion.
Memory modules
To remove the memory modules, use this procedure and illustration.
Table 5-6
Memory module descriptions and part numbers
Description Spare part number
For use in all countries and regions except the People's Republic of China
46 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
