To reassemble and replace the display assembly, reverse the removal procedures.
Fingerprint reader
To remove the fingerprint reader, use this procedure and illustration.
Table 5-12
Fingerprint reader description and spare part number
Description Spare part number
Fingerprint reader
NOTE: The fingerprint reader spare part kit does not include the fingerprint reader bracket or the
fingerprint reader cable. The fingerprint reader bracket is included in the Bracket Kit, spare part
number N96233-001. The fingerprint reader cable is included in the Cable Kit, spare part number
N96922-001.
N96242-001
Fingerprint reader cable: Included in the Cable Kit, spare part number N96922-001
Fingerprint reader foil: Included in the Miscellaneous Kit, spare part number N96244-001
Fingerprint reader blank: Included in the Plastics/Rubber Kit, spare part number N97208-001
Before removing the fingerprint reader, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 39).
2. Remove the bottom cover (see Bottom cover on page 39).
3. Remove the battery (see Battery on page 41).
4. Remove the WWAN module (see WWAN module on page 43).
5. Remove the SSD (see Solid-state drive on page 45).
6. Remove the fan (see Fan on page 50).
7. Remove the system board (see System board on page 52).
Fingerprint reader
65
To Next Page
Loading...
