Remove the fingerprint reader:
1. Remove the two Phillips M2.0 × 2.5 screws (1) that secure the fingerprint reader and bracket to
the computer.
2. Remove the fingerprint reader bracket (2) from the computer.
The fingerprint reader bracket is included in the Bracket Kit, spare part number N96233-001.
3. Remove the fingerprint reader (3) from the computer.
To replace the fingerprint reader, reverse the removal procedures.
Fingerprint reader cable
To remove the fingerprint reader cable, use this procedure and illustration.
The fingerprint reader cable is included in the Cable Kit, spare part number N96922-001.
Before removing the fingerprint reader cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 39).
2. Remove the bottom cover (see Bottom cover on page 39).
3. Disconnect the battery cable from the system board (see Battery on page 41).
4. Remove the WWAN module (see WWAN module on page 43).
5. Remove the SSD (see Solid-state drive on page 45).
6. Remove the fan (see Fan on page 50).
7. Remove the system board (see System board on page 52).
8. Remove the fingerprint reader (see Fingerprint reader on page 65).
Remove the fingerprint reader cable:
66
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
