HP ProCurve 5412ZL Access Security Guide

TACACS+ Authentication
Configuring TACACS+ on the Switch
CLI Commands Described in this Section
Command Page
show authentication
show tacacs
aaa authentication
console
Telnet
num-attempts <1-10 >
tacacs-server
host < ip-addr >
key
timeout < 1-255 >
5-9
5-10
5-11 through 5-14
5-15
5-15
5-19
5-20
Viewing the Switch’s Current Authentication
Configuration
This command lists the number of login attempts the switch allows in a single
login session, and the primary/secondary access methods configured for each
type of access.
Syntax:
show authentication
This example shows the default authentication configuration.
Configuration for login and enable access
to the switch through the switch console
port.
Configuration for login and enable access
to the switch through Telnet.
Figure 5-2. Example Listing of the Switch’s Authentication Configuration
5-9

HP ProCurve 5412ZL Specifications

General

Input Voltage	100-240 VAC
Jumbo Frame Support	Yes
Layer	Layer 3
Port Type	10/100/1000Base-T, SFP
Management	CLI, Web, SNMP