HP ProCurve 5412ZL Access Security Guide

Configuring Port-Based and Client-Based Access Control (802.1X)
Messages Related to 802.1X Operation
Messages Related to 802.1X Operation
Table 10-4. 802.1X Operating Messages
Message Meaning
Port
< port-list > is not an authenticator. The ports in the port list have not been enabled as 802.1X
authenticators. Use this command to enable the ports as
authenticators:
ProCurve(config)# aaa port-access
authenticator e 10
Port
< port-list > is not a supplicant. Occurs when there is an attempt to change the supplicant
configuration on a port that is not currently enabled as a
supplicant. Enable the port as a supplicant and then make
the desired supplicant configuration changes. Refer to
“Enabling a Switch Port as a Supplicant” on page 10-44.
No server(s) responding. This message can appear if you configured the switch for
EAP-RADIUS or CHAP-RADIUS authentication, but the
switch does not receive a response from a RADIUS server.
Ensure that the switch is configured to access at least one
RADIUS server. (Use show radius.) If you also see the
message Can’t reach RADIUS server <
x.x.x.x >, try the suggestions listed for that message
(page
6-36).
LACP has been disabled on 802.1X port(s).
To maintain security, LACP is not allowed on ports
configured for 802.1X authenticator operation. If you
configure port security on a port on which LACP (active or
passive) is configured, the switch removes the LACP
configuration, displays a notice that LACP is disabled on the
port(s), and enables 802.1X on that port.
Error configuring port
< port-number >: Also, the switch will not allow you to configure LACP on a
LACP and 802.1X cannot be run together.
port on which port access (802.1X) is enabled.
10-58

HP ProCurve 5412ZL Specifications

General

Input Voltage	100-240 VAC
Jumbo Frame Support	Yes
Layer	Layer 3
Port Type	10/100/1000Base-T, SFP
Management	CLI, Web, SNMP