HP ProCurve Series 6600 - 2 Installing the Switch

2-1
Installing the Switch
Included Parts
Installing the Switch
2
Installing the Switch
The HP ProCurve Series 6600 Switches come with an accessory kit that
includes the brackets for mounting the switch in a standard 19-inch telco rack,
or in an equipment cabinet. The brackets are designed to allow mounting the
switch in a variety of locations and orientations. For other mounting options
contact your local ProCurve authorized network reseller or ProCurve repre-
sentative. This chapter shows how to install the switch.
Caution If the switch is to be shipped in a rack, be sure to use only an HP 10K rack.
Mount the switch using rail mounting kit, (5070-6532). The switch warranty
may be voided.
Included Parts
The Series 6600 Switches have the following components shipped with them:
■ HP ProCurve Switch Quick Setup sheet
■ HP ProCurve Switches General Safety and Regulatory Information
booklet
■ Series 6600 Switch Safety and Regulatory Information sheet
■ Read Me First
■ Customer Support/Warranty booklet
■ Console cable
■ Accessory kits
5070-6315 used with the
J9263A and J9264A
5070-6316 used with the
J9265A
two mounting brackets two mounting brackets
eight 8-mm M4 screws to attach the
mounting brackets to the switch
eight 8-mm M4 screws to attach the
mounting brackets to the switch
four 5/8-inch number 12-24 screws to
attach the switch to a rack
four 5/8-inch number 12-24 screws to
attach the switch to a rack