2-4
Installing the Switch
Installation Procedures
Installing the Switch
Figure 2-1. Default air flow direction of the Series 6600 Switches is from power to
ports.
The direction of air flow can be reversed from the default direction shown in
figure 2-1 by reversing the direction of the fans. See step 3 below, Reversing
the air flow.
Installation Procedures
Summary
1. Prepare the installation site (page 2-5). Ensure the physical environ-
ment is properly prepared, including having the correct network cabling
ready to connect to the switch and having an appropriate location for the
switch. See page 2-3 for some installation precautions.
2. Verify the switch passes self test (page 2-5). Plug the switch into a
power source and observe that the LEDs on the switch’s front panel
indicate correct switch operation. When self test is complete, unplug the
switch.
3. (Optional) Reversing the air flow (page 2-8) The direction of air flow
can be reversed from the default direction by reversing the fans.
4. Mount the switch (page 2-10). The Switch can be mounted in a 19-inch
telco rack, or in an equipment cabinet.
To Next Page
Loading...
