2-9
Installing the Switch
Installation Procedures
Installing the Switch
3. Lift the fan assembly from the fan tray high enough to turn it over.
4. Rotate the fan assembly 180 degrees and replace the fan assembly into
the fan tray, sheet metal side up.
5. Take care to align the sensing pin between the two sensors and replace
the 4 retaining screws.
6. Replace the fan tray assembly into the switch.
7. Tighten the retaining screws.
Retaining
Screw
Rotating fan
tray
Rotated
position
Retaining
Screw
Sensing pin
Sensors
To Next Page
Loading...
