2-13
Installing the Switch
Installation Procedures
Installing the Switch
4. Slide the switch into the rails
Figure 2-9. Sliding the switch into the rails
5. Hold the switch with attached brackets up to the rack and move it
vertically until rack holes line up with the bracket holes, then insert and
tighten the four number 12-24 screws holding the brackets to the rack.
Figure 2-10. Mounting in a rack
Caution Make sure the air flow is not restricted in the front or back of the switch. See
Figure 2-1 on page 2-4 for the air flow direction.
To Next Page
Loading...
