9. Connect the power cable (1) and data cable (2) to the rear of the hard drive, and route the cables
through the retainer clip (3).
10. Slide the optical drive through the front bezel all the way into the bay (1) so that it locks in place (2),
and then connect the power cable (3) and data cable (4) to the rear of the drive.
11. Replace the access panel.
12. Reconnect the power cord and turn on the computer.
13. Lock any security devices that were disengaged when the access panel was removed.
36 Chapter 4 Removal and replacement procedures: Small Form Factor
To Next Page
Loading...
