Power supply
WARNING! To reduce potential safety issues, only the power supply provided with the computer, a
replacement power supply provided by HP, or a power supply purchased as an accessory from HP should be
used with the computer.
The power supply is located at the rear of the chassis. It is held in place by three Torx screws outside of the
chassis.
WARNING! Voltage is always present on the system board when the computer is plugged into an active AC
outlet. To avoid possible personal injury and damage to the equipment the power cord should be
disconnected from the computer and/or the AC outlet before opening the computer.
1. Prepare the computer for disassembly (Preparation for disassembly on page 18).
2. Remove the access panel (
Access panel on page 19).
3. Remove the drive cage (
Drive cage on page 26).
4. Remove the optical drive (
Removing a 9.5mm slim optical drive on page 30).
5. On the outside rear of the computer, remove the three Torx screws that secure the power supply to the
rear of the chassis.
6. On the inside of the chassis, remove the power cables from the clips built into the chassis (1).
44 Chapter 4 Removal and replacement procedures: Small Form Factor
To Next Page
Loading...
