Speaker
The speaker is attached to the front of the chassis under the bezel with two Torx screws.
1. Prepare the computer for disassembly (
Preparation for disassembly on page 18).
2. Remove the access panel (
Access panel on page 19).
3. Remove the front bezel (
Front bezel on page 20).
4. Remove the drive cage (
Drive cage on page 26).
5. Remove the optical drive (
Removing a 9.5mm slim optical drive on page 30).
6. On the outside front of the chassis, remove the two Torx T8 screws that secure the speaker to the
chassis.
7. On inside the chassis, disconnect the speaker wire from the white system board connector labeled SPKR
(1).
Speaker 49
To Next Page
Loading...
