Operations 18
WARNING: To reduce the risk of personal injury, be careful when pressing the server rail-release
latches and sliding the server into the rack. The sliding rails could pinch your fingers.
1. Do one of the following:
o In a server that uses thumbscrew rack ears, loosen the captive thumbscrews that secure the server
faceplate to the front of the rack, and then slide the server out of the rack.
o In a server that uses quick-release latch rack ears:
i. Open the latches on both sides of the server.
ii. If necessary, use a T-25 Torx screwdriver to loosen the shipping screws.
iii. Slide the server out of the rack.
2. After performing the installation or maintenance procedure, slide the server back into the rack, and then
press the server firmly into the rack to secure it in place.
3. Do one of the following:
o In a server that uses thumbscrew rack ears, tighten the captive thumbscrews,
o In a server that uses quick-release latch rack ears, if necessary, tighten the shipping screws.
Access the product rear panel
Opening the cable management arm
To access the server rear panel:
1. Release the cable management arm.
To Next Page
Loading...
