Operations 26
2. If installing the secondary PCI riser cage, remove the PCI blank.
Retain the blank and screws for future use.
3. Align the PCI riser board with the corresponding connectors on the system board, and then press down
the PCI riser cage.
4. Tighten the two screws to secure the cage.
5. Install the access panel (on page 21).
6. Do one of the following:
o Slide the server into the rack.
o Install the server into the rack ("Installing the server into the rack" on page 31).
7. Power up the server (on page 17).
To Next Page
Loading...
