Setup 34
b. Bend the plug end of the power cord in the position shown in the following image.
c. Secure the power cord in the hook-and-loop strap as shown in the following image.
5. Employ best practices to route and manage the power cords and other cables in the server rear panel.
IMPORTANT:
When using cable management arm components, be sure to leave enough slack
in each of the cables to prevent damage to the cables when the server is extended from the rack.
6. Use the hook-and-loop strap included in the server shipping carton to secure the power cords and the
other rear panel cables to the rack rail. For detailed instructions, see "Installing the rack rail
hook-and-loop strap (on page 35)."
7. Connect the power cord to the power source.
To Next Page
Loading...
