Hardware options installation 40
5. Remove the two metal brackets from the drive carrier.
6. Install the drive in the carrier.
7. Install the drive.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
8. If removed, install the security bezel ("Security bezel option" on page 38).
9. Connect each power cord to the server.
10. Connect each power cord to the power source.
11. Power up the server (on page 17).
To configure arrays, see the HP Smart Storage Administrator User Guide on the HP website
(http://www.hp.com/go/smartstorage/docs).
To Next Page
Loading...
