Hardware options installation 61
b. Tighten the T-15 screw to secure the component.
9. Align the PCI riser board with the corresponding connector on the system board, and then press down
the riser cage.
10. Tighten the two screws to secure the assembly.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all PCI slots have either an expansion slot cover or an expansion board installed.
11. Install the access panel (on page 21).
12. Do one of the following:
o Slide the server into the rack.
o Install the server into the rack ("Installing the server into the rack" on page 31).
13. Power up the server (on page 17).
To Next Page
Loading...
