System BIOS configuration 7
NOTE: System Serial Number and Asset Tag are not saved in CMOS. These are not affected when
CMOS defaults are loaded or CMOS is cleared.
Navigating through the Setup Utility
Use the keys listed in the legend bar on the bottom of the Setup screen to access the various menu
and submenu screens of the Setup Utility. Figure 1 in the previous section shows the legend bar at the
bottom of the Main menu.
Table 1 Setup Utility navigation key Setup Utility navigation keys lists these
legend keys and their respective functions.
Table 1 Setup Utility navigation keys
Key Function
← and → Move between selections on the menu bar.
↑ and ↓ Move the cursor to the field you want.
The currently selected field is highlighted. The right side of each menu screen displays the Item
Specific Help
panel. This panel displays the help text for the selected field. It updates as you move
the cursor to each field.
<+>, <–> Select a value for the currently selected field if it is user-configurable.
Press the (+) or (-) keys repeatedly to scroll through each value one at a time, or press the Enter key to
choose from a pop-up menu that displays all possible values at once.
A parameter that is enclosed in square brackets [ ] is user-configurable.
Grayed-out parameters are not user-configurable for one of the following reasons:
• The field value is auto-configured or auto-detected.
• The field value is informational only.
• The field is password-protected.
Enter Select a field value or display a submenu screen.
Tab Use [ENTER], [TAB] or [SHIFT-TAB] to select a field.
Esc When you press this key:
• On a primary menu screen, the Exit menu displays.
• On a submenu screen, the previous screen displays.
• On a pop-up menu, closes the pop-up without making a selection.
F1 Displays the General Help window. See the Figure 2.
The General Help window describes other Setup navigation keys that are not displayed on the
legend bar.
F9 Loads BIOS default.
F10 Saves all changes to settings and closes the Setup Utility.
To Next Page
Loading...
