Removal and replacement procedures 50
Figure 22 Installing the hot-plug hard drive assembly
To remove hard drive:
1. Press the hard disk carrier button to release the ejector lever.
2. Use the HDD carrier latch to pull the drive out of the cage.
Make sure to support the drive when pulling it out of the cage.
3. Pull the hard drive assembly out of the drive bay.
Figure 23 Removing the hot-plug hard drive
To install a non-hot-plug hard drive:
1. Loosen four screws from the top part of the carrier
2. Put the non-hot-plug hard drive disk into the carrier
3. Fasten the HDD to the carrier using the screws. ( two on each side).
To Next Page
Loading...
