Removal and replacement procedures 73
Figure 61 System fan connections
Device number Connector
System fan 1 P23 on the system board
System fan 2 P25 on the system board
System fan 3 P21 on the system board
System fan 4 P19 on the system board
System fan 5 P18 on the system board
System fan 6 P24 on the system board
System fans 1 to 5 are for the memory modules and processors, while system fan 6 is for the PCI slots and
system chipsets.
A new system fan can be installed to allow the server to operate properly in case a default system fan
becomes defective.
To remove the system fan:
1. Disconnect the fan cable from its corresponding board connector.
2. Release the fan cable from the cable clip.
3. Lift the system fan away from the chassis.
To Next Page
Loading...
