Removal and replacement procedures 30
6.
Remove the media cage (on page 33).
7. Use the T-15 Torx screwdriver to loosen the two screws on each side of the front bezel.
NOTE: The T-15 Torx screwdriver is shipped with the server and can be located on the rear panel.
8. Slide the bezel to the left, release the USB cover by gently lifting the plastic latch, and then detach
the bezel.
To replace the component, reverse the removal procedure.
SAS/SATA backplane board
To remove the component:
1. Power down the server (on page 26).
2. Extend the server from the rack (on page 26).
3. Remove the access panel.
4. Disconnect the hard drive cables and power cables.
5. Remove all hard drives (on page 27) and hard drive blanks (on page 29).
To Next Page
Loading...
