Removal and replacement procedures 35
8.
Remove the diskette drive.
To replace the component, reverse the removal procedure.
Power button/LED board
To remove the component:
1. Power down the server (on page 26).
2. Extend the server from the rack (on page 26).
3. Remove the access panel.
4. Remove the fan assembly (on page 31).
5. Disconnect cables from any devices installed in the media cage, if necessary ("Media cage cables"
on page 47).
6. Remove the BBWC battery (on page 32), if necessary.
7. Remove the media cage ("Media cage" on page 33).
8. Remove the power button/LED board.
To Next Page
Loading...
