Removal and replacement procedures 42
5.
Remove the heatsink.
6. Open the processor retaining clip and bracket, and remove the processor.
To replace the component, reverse the removal procedure.
IMPORTANT: When replacing the heatsink, check the label on top to be sure the heatsink is properly
oriented.
System board
To remove the component:
1. Power down the server (on page 26).
2. Remove the server from the rack (on page 27).
3. Remove the access panel.
4. Remove the PCI riser board assembly ("PCI riser board assembly" on page 36).
5. Remove all DIMMs ("DIMMs" on page 39).
6. Remove the fan assembly ("Fan assembly" on page 31).
To Next Page
Loading...
