d. Disconnect the SATA DVD cable from the rear of the DVD drive.
To insert DVD drive:
7. For an SFF DVD drive, do the following:
a. Install the DVD drive using the screws from this kit and a T-10/T-15 Torx screwdriver.
b. Reconnect SATA DVD cable to rear of DVD drive.
c. Connect VGA and USB cables to connectors at rear of motherboard.
d. Clip the cable to the power supply air baffle when routing it along the edge of the
system board.
8. Install the access panel.
9. Slide the server into the rack.
10. Connect each power cord to the server.
11. Connect each power cord to the power source.
12. Power up the server.
Related links
DVD-RW problems on page 22
NIC problems
Symptoms
• Network controller is installed, but not working.
• Network controller has stopped working.
• Network controller stopped working when an expansion board was added.
Internal Field Replaceable Units
November 2015 Maintaining and Troubleshooting the HP ProLiant DL360 G9 Server 25
Comments on this document? infodev@avaya.com
To Next Page
Loading...
