HP ProLiant DL360 Generation9

QuickSpecs
HPE ProLiant DL360 Generation9 (Gen9)
Configuration Information
- Factory Integrated Models
Page 27
BIOS Mode
HP Legacy FIO Mode Setting
NOTE: If selected, then B140i will not be supported and can no longer be a primary
controller therefore, SAS internal controller must be selected to be the primary controller
758959-B22
Controller State
HP FIO Enable B140i Setting
NOTE:
Must be selected when B140i is used as the primary controller and RAID is desired.
784308-B21
HP Mfg FIO Enable HBA Mode Setting
NOTE: When selected if H240ar/H240 are used as the primary controller then RAID is not
allowed.
792962-B21
HPE Insight
Software
HP Insight Control including 1yr 24x7 support ProLiant ML/DL/BL-bundle Single Server FIO
License
C6N36A
HP Insight Control including 1yr 24x7 support ProLiant ML/DL/BL-bundle Single Server FIO
E-LTU
C6N36ABE
HPE Converged
Infrastructure
Software
HPE OneView Advanced (with HPE iLO Advanced)
HP OneView for ProLiant DL Server incl 3yr 24x7 Supp FIO Bundle Physical 1 Svr Lic
E5Y43A
HPE OneView Advanced (without HPE iLO Advanced)
HP OneView w/o iLO including 3yr 24x7 Support FIO 1 Server LTU
P8B31A
Step 4: Choose Additional Options for Factory Integration from Core and Additional Options
Sections below.
CAUTION: Hewlett Packard Enterprise recommends that a minimum of two people are
required for all Rack Server installations. Please refer to your installation instructions for
proper tools and number of people to use for any installation