HPE ProLiant DL360 Generation9 (Gen9)
NOTE: Some options may not be integrated at the factory. To ensure only valid configurations are ordered, Hewlett Packard
Enterprise recommends the use of an Hewlett Packard Enterprise approved configurator. Contact your local sales
representative for additional information.
HP DL360 Gen9 2SFF SAS/SATA Universal Media Bay Kit
8SFF config to a 10SFF config.
is not supported on the 4LFF CTO Server.
option kit cannot be used with the DVD-ROM or DVD-RW Universal Media Bay
This kit contains a cable to attach the 2 drives to the internal B140i SATA
For SAS, an alternate storage controller and its associated cable kit are required.
HP DL360 Gen9 SFF DVD-RW/USB Universal Media Bay Kit
DVD-RW, USB 2.0 and VGA included.
This option kit cannot be used
with the 2 SFF SAS/SATA option kit (764630-B21).
HP DL360 Gen9 SFF DVD/USB Universal Media Bay Kit
NOTE: DVD ROM, USB 2.0 and VGA included.
This option kit cannot be used with the 2 SFF SAS/SATA option kit (764630-B21).
HP DL360 Gen9 SFF USB/VGA Universal Media Bay Kit
Adds front VGA and USB 2.0
be used with the 2 SFF SAS/SATA option kit (764630-B21).
HP DL360 Gen9 LFF USB/VGA Kit
NOTE: Adds front VGA and USB 2.0 ports to LFF Model.
This option kit cannot be used with the 2 SFF SAS/SATA Option Kit (764630-B21).
HP DL360 Gen9 High Performance Heat Sink Kit
NOTE: These are included in some higher Watt processors (see processor section),
but may also be added to lower power processors to reduce fan power consumption.
HP DL360 Gen9 Rear Serial Port and Enablement Kit
HP DL360 Gen9 Location Discovery Services Ear Kit
NOTE: Requires ProLiant Location Discovery Services Infrastructure within server
racks.
HP DL360 Gen9 SFF Systems Insight Display Kit
NOTE: Adds a System Insight Display for improved diagnosis capabilities on an 8FF or
10SFF model.
HP DL360 Gen9 LFF Systems Insight Display Kit
NOTE: Adds a System Insight Display for improved diagnosis capabilities on a 4LFF
model.
HP DL360 Gen9 NVMe 2 Solid State Drive Express Bay Enablement Kit
This option provides support for up to 2 NVMe SFF drives.
This option cannot be used with the Universal Media Bay Kit.
The HPE DL360 Gen9 High Performance Fan Kit (766201-B21) will be
required with this option.
The PCIe card in this enablement kit can only be populated in slot1 of primary
riser or in slot3 of secondary optional FH riser.
HP DL360 Gen9 6 NVMe + 4 SAS/SATA Express Bay Enablement Kit
This option kit provides support for up to
6 NVMe drives (drives 5-10).