Cabling 66
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend the server from the rack (on page 26).
4. Remove the access panel ("Access panel" on page 27).
5. Disconnect any SAS cables from the hard drive cage and either the embedded SAS controller or an
optional SAS controller. Do not disconnect the power cable.
Remove two SAS cables from an SFF configuration, or one cable from an LFF configuration.
The server may look different than the one shown in the following illustrations, depending on the
server model.
6. Disconnect the SATA cable from the optical drive and the SATA connector on the system board. The
optical bay is disabled with the chipset SATA cable option.
7. Connect the chipset SATA cable:
To Next Page
Loading...
