Component identification 81
NIC LEDs
Solid green = Network link
Flashing green = Network link with activity
If power is off, the front panel LED is not active. For
status, see "Rear panel LEDS and buttons ("Rear panel
components" on page 76, on page 77)."
Power supply
Amber = Failed power supply
PCI riser LED
Amber = Incorrectly installed PCI riser board
Over temp LED
Amber = High system temperature detected
AMP status LED
Solid green = Advanced Memory Protection active
Solid amber = Memory failure has occurred.
Flashing amber = Invalid AMP memory configuration
Power cap LED
Off = System is in standby, or no cap is set.
Solid green = Power cap applied
For more information, see "Systems Insight Display LED combinations (on page 81)."
Systems Insight Display LED combinations
When the health LED on the front panel illuminates either amber or red, the server is experiencing a
health event. Combinations of illuminated Systems Insight Display LEDs, the system power LED, and the
health LED indicate system status.
Systems Insight
Display LED and
color
Health LED System power
LED
Status
Processor (amber)
One or more of the following conditions may
exist:
Processor in socket X has failed.
Processor X is not installed in the
socket.
Processor X is unsupported.
ROM detects a failed processor during
POST.
Processor (amber)
Processor in socket X is in a pre-failure
condition.
One or more DIMMs have failed.
DIMM in slot X is in a pre-failure condition.
Over temp (amber)
The Health Driver has detected a cautionary
temperature level.
Over temp (amber)
The server has detected a hardware critical
temperature level.
The PCI riser cage is not seated properly.
One fan has failed or has been removed.
Fan (amber)
Two or more fans have failed or been
removed.
Power supply (amber)
One or more of the following conditions may
exist:
Only one power supply is installed and
that power supply is in standby.
To Next Page
Loading...
