Hardware options installation 56
9.
Close the full-length expansion board retainer.
10. Connect any required internal or external cables to the expansion board. See the documentation that
ships with the expansion board.
11. Install the PCI riser cage.
12. Install the access panel (on page 24).
PCI riser board option
CAUTION: For proper cooling do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
1. Power down the server (on page 22).
2. Extend the server from the rack (on page 22).
3. Remove the access panel (on page 23).
4. Remove the PCI riser cage (on page 26).
To Next Page
Loading...
