Hardware options installation 45
14.
Close the heatsink retaining bracket.
15. Remove the fan blanks in bays 5 and 6. For fan location and numbering information, see "Hot-plug fans
(on page 22)" or the label attached to the access panel.
16. Install the fans into bays 5 and 6.
17. Install the air baffle.
18. If any full-length expansion boards are installed, complete the following steps:
a. Install the PCI riser cage (on page 29).
b. Install the full-length expansion board retainer (on page 30).
19. Install the access panel (on page 26).
20. Install the server into the rack ("Installing the server into the rack" on page 35).
21. Power up the server (on page 24).
To Next Page
Loading...
