Server operations 25
• Diskette drive
• Hard drives
To extend the server from the rack:
1. Release the two levers on the lower outside corners of the rack.
2. If the server is in a rack and in the shipping configuration, remove the two shipping screws directly
behind the levers.
3. Extend the server on the rack rails until the server rail-release latches engage.
NOTE: The release latches will lock into place when the rails are fully extended.
WARNING: To reduce the risk of personal injury or equipment damage, be sure that the rack
is adequately stabilized before extending a component from the rack.
WARNING: To reduce the risk of personal injury, be careful when pressing the server rail-
release latches and sliding the server into the rack. The sliding rails could pinch your fingers.
To Next Page
Loading...
