HP Proliant DL580 - Memory Configuration and Testing

Memory options 78
6. Close the memory board.
IMPORTANT: Be sure that the locking switch is unlocked. The memory board will not seat in
the server if the locking switch is locked.
7. Install the memory board.
8. Close the ejector lever, and lock the locking switch.
9. Power up the server (on page 24).
10. Configure the memory ("Configuring the memory" on page 78).
11. Look at the memory board LEDs ("Memory board components and LEDs" on page 9) to be sure that
the memory board is functioning properly.
Configuring the memory
Configuring the memory system of the server requires configuring both hardware and software.