Memory options 76
7.
Close the ejector lever, and lock the locking switch.
NOTE: The board status LED might flash green for several minutes while the board is
rebuilding.
8. Configure the memory ("Configuring the memory" on page 78), if applicable.
9. Reference the memory board LEDs ("Memory board components and LEDs" on page 9) to be sure
that the memory board is functioning properly.
Removing and installing a memory board (non-hot-plug)
1. Power down the server (on page 24).
2. Unlock the locking switch, and open the release latch.
3. Use the ejector lever to pull the memory board out of the server.
To Next Page
Loading...
