Hardware options installation 67
8.
Connect the cable.
9. Install the capacitor pack.
10. Install the SPI board.
11. Install the access panel (on page 27).
12. Slide the server back into the rack.
13. Power up the server (on page 25).
HP Trusted Platform Module option
Use these instructions to install and enable a TPM on a supported server. This procedure includes three
sections:
1. Installing the Trusted Platform Module board (on page 68).
2. Retaining the recovery key/password (on page 68).
3. Enabling the Trusted Platform Module (on page 70).
Enabling the TPM requires accessing RBSU ("HP ROM-Based Setup Utility" on page 72). For more
information about RBSU, see the HP website (http://www.hp.com/go/ilomgmtengine/docs).
To Next Page
Loading...
