HP ProLiant ML310 Generation 5p User Manual

Hardware options installation 31
4.
Install the hard drive.
5. Determine the status of the drive from the hot-plug SAS hard drive LED combinations ("Hot-plug SATA or
SAS hard drive LEDs" on page 8).
6. Install the bezel.
7. Resume normal server operations.
SATA optical drive
For clarity, the following illustrations include option cabling only.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To install the component:
1. Power down the server (on page 16).
2. Remove the bezel (on page 17).
3. Remove the access panel (on page 18).
4. Remove the applicable media bay blank ("Remove a media bay blank" on page 19).

HP ProLiant ML310 Generation 5p Specifications

General

Processor Sockets	1
Chipset	Intel 3200
Memory Slots	4
Storage	SATA or SAS
Form Factor	Tower
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Processor	Intel Xeon 3000 sequence, Dual-Core Intel Pentium, Intel Celeron
Memory	Maximum 8 GB PC2-6400E DDR2 SDRAM
Drive Bays	4 LFF SATA Hot-Plug or Non-Hot-Plug
Storage Controller	HP Smart Array E200i
RAID Support	RAID 0, 1
Optical Drive	Optional
Network	Embedded NC105i PCI Express Gigabit Server Adapter