Optical drive
The optical drive mounts on the exterior, rear of the computer. It is secured with two screws.
For a list of available optical drives, see Mass storage devices on page 11.
1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 21).
2. Remove the rear port cover (see Rear port cover on page 23).
3. Remove the stand (see Stand on page 21).
4. Remove the rear cover (see Rear port cover on page 23).
5. Remove the two Phillips screws (1) that secure the drive carrier to the computer, move the carrier back
and forth (2), and then slide the carrier away from the connector to remove it (3).
IMPORTANT: Do not lift the drive as you remove it.
26 Chapter 4 Removal and Replacement Procedures
To Next Page
Loading...
