Power button board
The power button board is located at the bottom, right of the computer. It is spared with a plastic holder.
To remove the power button board:
1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 21).
2. Remove the stand (see Stand on page 21).
3. Remove the rear port cover (see Rear port cover on page 23).
4. Remove the speaker cover (see Speakers on page 42).
5. Disconnect the power button board cable from the system board ZIF connector (1), and then push the
connector end of the cable through the hole (2) that allows the cable to route to the front of the chassis.
6. Locate the power button board under the speaker cover.
7. Remove Phillips screw (1) that secures the power button board to the computer.
Power button board 45
To Next Page
Loading...
