Rear enclosure and display assembly
Rear enclosure and display assembly in 23.8-inch models
IMPORTANT: Removing the rear enclosure is a very involved process. To successfully disassemble, be sure
to follow all steps in the correct order. If you break the clips or otherwise damage the rear cover during
removal, a replacement cover is available. If you have to replace the cover, be sure to remove the webcam
from the old cover and install on the new cover.
To remove the rear enclosure and main chassis:
1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 21).
2. Remove the stand (see Stand on page 21).
3. Remove the rear port cover (see Rear port cover on page 23).
4. Remove the speaker cover (see Speakers on page 42).
5. Remove the system board (see System board on page 39).
6. Remove the four screws (1) that secure the webcam carrier to the computer.
7. Move the webcam carrier aside so you can access the screw underneath (2).
Rear enclosure and display assembly 47
To Next Page
Loading...
